The following words inspect the stack non-destructively:
.s– tools “dot-s”
Display the number of items on the data stack, followed by a list
of the items (but not more than specified by
TOS is the right-most item.
f.s– gforth “f-dot-s”
Display the number of items on the floating-point stack, followed
by a list of the items (but not more than specified by
maxdepth-.s; TOS is the right-most item.
maxdepth-.s– addr gforth “maxdepth-dot-s”
A variable containing 9 by default.
display at most that many stack items.
There is a word
.r but it does not display the return stack!
It is used for formatted numeric output (see Simple numeric output).
depth– +n core “depth”
+n is the number of values that were on the data stack before +n itself was placed on the stack.
fdepth– +n float “f-depth”
+n is the current number of (floating-point) values on the floating-point stack.
clearstack... – gforth “clear-stack”
remove and discard all/any items from the data stack.
clearstacks... – gforth “clear-stacks”
empty data and FP stack
The following words inspect memory.
?a-addr – tools “question”
Display the contents of address a-addr in the current number base.
dumpaddr u – unknown “dump”
see allows to inspect code:
see"<spaces>name" – tools “see”
Locate name using the current search order. Display the definition of name. Since this is achieved by decompiling the definition, the formatting is mechanised and some source information (comments, interpreted sequences within definitions etc.) is lost.
xt-seext – gforth “xt-see”
Decompile the definition represented by xt.
simple-see"name" – gforth “simple-see”
a simple decompiler that’s closer to
simple-see-rangeaddr1 addr2 – gforth “simple-see-range”
see-code"name" – gforth “see-code”
simple-see, but also shows the dynamic native code for
the inlined primitives (except for the last).
see-code-rangeaddr1 addr2 – gforth “see-code-range”